Joining Adapters and Field Points

I received my order a while ago, all seem like great products. Am soon going to tune my new setup, powerful enough to handle 800grs range arrows.

I ordered 300grs brass field points and the adapter test kit for this purpose, my challenge is how to get them to stick together! Please share your suggestions.
Since brass is fairly soft, I have considered heating the points to simply shrink fit the adapters!

This entry was posted in $1$s. Bookmark the permalink.

One thought on “Joining Adapters and Field Points

  1. Thorsten….most heat the adaptor than apply hot melt glue on the tapered section that fits into the field point…then heat the field point and inert adaptor into the hot field point ..let cool….
    A cold method is to use a epoxy glue no heat necessary and good bond..
    Hope this helps
    Joe Furlong

Leave a Reply